(which seems to work), but that needlessly uses up a USB port. It stores some values like the IP address of the TFTP server (on your PC) to. This can hardly be compared to NVRAM/TFFS-approach of other bootloaders. I have an extra Logitech unifying receiver I could leave plugged in Das U-Boot uses a small amount of space on the flash storage usually on the same partition it is stored on to store some important configuration parameters. and itĪppeared to automatically re-add the serial and stop boot. I put Fedora 36 Server on an SD card, and set the U-Boot stdin, stdout,Īnd stderr environment variables to exclude serial (which wrote U-Boot stops boot on serial input, and the GPS module is always sending Module serial data on the first serial port lines. Writer's Note: If this post helped you in any way possible, please do take a minute to like, share or comment.I have a Pi 4B 2G with a Uputronics u-blox GPS HAT, which puts the GPS The Linux autoboot sequence in U-Boot is controlled by the two environment variables called bootdelay and bootcmd. It can be seen from the analysis that the function that finally enters the kernel is: kernel_entry(0, machid, r2)Īt this point, bootm successfully passed the parameters to the kernel and jumped to the kernel. The header is defined as: typedef struct image_header //Enter the kernel This can be used to represent uImage=uboot header+zImage. This kernel consists of two parts, one is the header and the other is the real kernel. NOT GOING INTO MORE DETAILS IN EACH STEP.ħ-8: Decompress bootimage into ramdisk and kernel and load into DRAM, initialize dtb The kernel booted with uboot is uImage.
0 Comments
Leave a Reply. |